MAG2000X™ Underwater cutting system with knife switch
- Cutting torch.
- Oxygen hose 30' reach.
- Oxygen regulator 2 stage.
- Knife switch.
- Flame cutting tubes.
- Arc cutting rods.
- Welding stinger.
- Wet welding electrodes.
- Extra collets.
- CD Instructions.
- UPS 4 packages.
- 75 lbs (29 kg) weight.
The MAG2000X™ represents the most advanced state of the art torch system on the market today. Cut, gouge or pierce any material in seconds for a variety of work benefits using our fin wrapped flame tubes. For example, effect emergency repairs, routine maintenance or salvage with the same torch. Use an arc rod to get incredibly long cuts. Our patented arc rods last up to 20 minutes of continuous cutting on land, and several minutes of cutting in underwater settings. Set is straight forward and takes approximately five minutes. Hook the oxygen hose to the regulator and the regulator to a CGA 540 bottle. Connect the cable to a D.C. welder if arc mode is desired. Insert a flame tube or arc rod and you are ready to begin cutting. Divers can now forget material barriers. Flame tubes can cut through rust, scale, paint, slag, concrete linings, barnacles and more. With both rods and tubes at your disposal, small wonder this is such a popular model.
Consider ordering this system with our new 24 volt marine ignition system and eliminate the need for a welding machine as an ignition power source.
Ships with quick cable connect and welding lead (not shown). The offset nose eliminates high pressure bottlenecks that can rob performance.
|
